Himiway Cruiser ST (D3 ST) Charger
The Himiway Cruiser ST (D3 ST) uses a 54.6V charger with a Himiway plug.
You need:
A 54.6V charger with a Himiway plug
Tip: Voltage must match; amps can be equal or lower.
Charger
Himiway 48V charger
More details
- Output
- 54.6V
- Plug
- Himiway
- Type
- External brick
Compatible alternatives (not made by Himiway)
Matched by voltage, output and plug. Questions about fit? Ask the seller before buying.
We may earn a small commission if you buy through these links, at no extra cost to you.
Stock changes often, so availability may vary by store.
Match the voltage on your old charger's label. 36V batteries use 42V chargers, 48V use 54.6V and 52V use 58.8V. These can share the same plug, so check the volts before you buy. Voltage guide
Specs
| Brand | Himiway |
|---|---|
| Type | E-bike |
| Battery voltage | 48V |
| Charger output | 54.6V |
| Plug/connector | Himiway |
| Match | ✓ Confirmed match |
Common questions
Can I use a universal charger on the Cruiser ST (D3 ST)?
Only use one that outputs 54.6V and has the Himiway plug. Never use a charger with a different voltage.
How do I know my charger is bad?
Common signs: the charger light stays the same color (or never lights) when plugged into the e-bike, the battery never reaches full, the brick gets very hot or smells burnt, or a multimeter reads no voltage (or far below the rated output) at the plug. Also check the cable and plug pins for damage.
Where can I buy a replacement charger for the Himiway Cruiser ST (D3 ST)?
Himiway's official store, Amazon, or eBay have the charger shown on this page.