Electra Townie Go! 7D (Gen 2) Charger
The Electra Townie Go! 7D (Gen 2) uses the Hyena system, so it needs a Hyena charger. Generic chargers don't fit.
You need:
A Hyena charger made for your battery
Charger
Hyena Gen 2 charger
More details
- Output
- Check the output on your old charger's label.
- Plug
- Hyena
- Type
- External brick
We may earn a small commission if you buy through these links, at no extra cost to you.
Stock changes often, so availability may vary by store.
Match the voltage on your old charger's label. 36V batteries use 42V chargers, 48V use 54.6V and 52V use 58.8V. These can share the same plug, so check the volts before you buy. Voltage guide
Specs
| Brand | Electra |
|---|---|
| Type | E-bike |
| Battery voltage | Hyena |
| Charger output | Check the output on your old charger's label. |
| Plug/connector | Hyena |
| Match | Plug not confirmed |
Common questions
Can I use a universal charger on the Townie Go! 7D (Gen 2)?
No. The Townie Go! 7D (Gen 2) uses the Hyena system and needs a Hyena charger. Generic chargers don't fit.
How do I know my charger is bad?
Common signs: the charger light stays the same color (or never lights) when plugged into the e-bike, the battery never reaches full, the brick gets very hot or smells burnt, or a multimeter reads no voltage (or far below the rated output) at the plug. Also check the cable and plug pins for damage.
Where can I buy a replacement charger for the Electra Townie Go! 7D (Gen 2)?
Electra's official store has the charger shown on this page.